Walk in tiled shower install#
Walk in tiled shower crack#

Once cured, move on to the walls and fixtures. The silicone used on the shower base will properly cure within 24 to 48 hours. The drainpipe is now connected to the drain assembly, completing your shower base installation.

Walk in tiled shower install#

Install the remainder of the drain assembly, following the instructions provided. Step 5 - Connect Drain Pipe to Drain Assembly Remove any excess silicone, and fasten the shower base to the walls using only the factory provided screws. Lower the shower base back into position, making sure it is level. If necessary, trim the drainpipe down to 0.25-inches below the top of the drain body.Īpply silicone to the underside of the shower base, around the sub-floor drain opening, and around the threshold. The drainpipe must not extend above the drain body. Place the shower base on the subfloor, making sure that 1/8-inch space between the shower base flange and the studs.

Walk in tiled shower crack#

Make sure not to over tighten any of the parts, as this may crack the shower base. Install the drain assembly parts as noted in the instructions provided up until the installation of the shower base. Remove the excess silicone using rubbing alcohol on a cloth. Insert the drain body into the drain hole, and press into place to secure. Apply a layer of silicone around the opening of the drain. Clean the drain opening with rubbing alcohol, then wipe clean the surface and inside of the drain opening. Step 3 - Attach Drain Assembly to Shower BaseĮlevate your shower base for access to the top and bottom. If the subfloor is not level, pour in floor leveling compounds to fill the uneven areas. This ensures the water will drain evenly from your shower. Check your subfloor with a level to make sure it is completely level. Your subfloor must be level and cleared off. The drainpipe should extend at least 0.5-inches above the subfloor. The drainpipe hole in the subfloor should have a six inch diameter, and will be larger than the actual drainpipe to allow for the drain assembly that extends below the shower base.

Relocate the drain if the location does not match the template. Make sure the existing drainpipe hole matches the drainpipe location on the template. Place the template included with your shower base on the shower floor. Installing the Shower Base Step 1 - Prepare the Subfloor